Prototyping and Design


Our unique design and development process allows our clients to start with only a napkin sketch, where we then run wild with all aspects of design and development, as well as eventual prototyping to prove their own unique consumer product.

  • Prototyping is part of what we do and is involved in every aspect of our design process.  We have state of the art product development equipment that allows us to do prototype manufacturing in a matter of hours once the design process is complete.
  • Mechanical Properties testing gives us the composite material properties which are dependent on the material quality and manufacturing process. These tests reveal us better optimization and close result to FE analysis.

We often prepare material samples according to ASTM 3039 standard to determine the in-plane tensile properties. Also results from this step are used in optimization and analysis phase to get rigid conclusions. Once we are satisfied with material properties, we then proceed towards next stages of manufacturing process.

To find the other properties of composite material we do find the fiber volume fraction to get the other properties. To do so we followed the ASTMD 3171 – 99 to find out the constituent content of composite material. After that we use Helius software for rest of properties to do further analysis in CAE .

We do strive to be your best full service product development firm in the industry. We look forward to helping you with your next big IDEA!